Saltar al contenido

▷▷ 2021 ▷ How to remove the anti-theft device from a car radio ventos.site

4 julio, 2021


How to remove the anti-theft device from a car radio

Many vehicle manufacturers hope to prevent theft by installing car radio alarms, sometimes known as PassLocks or Theftlocks. The lock is programmed through the car’s ignition, the actual radio, or the electrical wiring or fuses. Depending on the specs of your car, there are a couple of different ways to disable the alarm if it is causing problems allowing your vehicle to start.

Use of vehicle identification number

Step 1: how to disable a car’s burglar alarm

Find the car’s VIN number by looking in the title, on the driver’s side door, or on the front of the windshield.

Step 2: how to remove the anti-theft device from a car

Open the User Manual at the location that tells you about your car radio and its contents. This area is usually “Information Systems” or something similar.

step 3; how to remove the anti-theft system from a car

Find the section that tells you which button, based on your vehicle’s specifications, to hold for 5 seconds until the screen flashes for you to enter a code. (This button is usually a “Tone” button or an “Auto Program” button).

Step 4: how to deactivate a car’s anti-theft device

Check the VIN number on the display and follow the instructions in the manual on how to disarm the alarm on the radio. This will allow the radio to be used in other vehicles that do not have your car’s VIN number. Reassemble the radio by repeating the steps provided in the manual and entering the VIN number back into the radio.

Cars with PassLock or Theftlock

Step 1: how to remove anti theft from a car

Use an original key (not copied) and insert it into the ignition.

Step 2: remove car radio

Turn the key to the “On” position. The “Theft System” light begins to flash on the dash.

Step 3: how to remove the car radio

Leave the key in this position for 10 minutes until the “Theft System” light stops flashing and turns off.

Step 4: how to disable burglar alarm

Turn the key to the “Off” position and leave it there for five seconds. Start the car and the engine will start, disarming the theft system and allowing your car to run.

Items you’ll need: how to remove the theft system

  • VIN number
  • Original car key, which was made by the manufacturer.
  • User manual



ventos link